Hydraulic operated pipe saws, especially used for the preparation of pipe segments in PE, PP and other thermoplastic materials for the production of bends, tee and other manufacturing. the reduction rate of the saw is hydraulically controlled like the belt clamp used for fixing the pipe section. The saw blade is made in Germany.
Hydraulically raised and lowered cutting cycle;
67-degree maximum cutting angle allows the production of segments for bends, tees and Y-branch tees;
Angular cutting error equal to or less than 1 degree;
Speed of saw blade 195m/min;
Pipe clamping straps.
Malfunction analyzes:
① Pipes cannot be clamped.
② Pressure relay is not adjusted well.
③ The clamping cylinder is leak.
Solutions:
① Adjust the clamping pressure;
② Adjust the pressure relay;
③ Replace the oil ring
Malfunction analyzes
① System pressure is too high or low;
② Throttle valve is adjusted improperly;
③ Controllable cheek valve is adjusted improperly.
Solutions
① Adjust the system pressure;
② Adjust the throttle valve;
③ Adjust the single direction valve.
Malfunction analyzes
① The overflow valve core is blocked
② Oil filter is blocked.
③ Overflow valve core is blocked
Solutions
① Disconnect & wash or change the overflow valve
② Wash the oil filter.
③ Disassemble and clean the overflow valve core.
